10. Use cable-tie to tie up the cables and make sure to tighten the cable tie if the cable tie was cut.
6-6. WIFI Board
Applicable Model : iX Sense / iX Auto
Auto/Sense Disassembly Steps:
1. Remove the 4 screws under the bottom and top cover can be separated. <Refer to 6.1>.
2. Remove the mainboard <Refer to 6.3>.
3. Remove the Blower & Air path module<Refer to 6.5>
4. Remove one screw which is right beside the WIFI board.
To Next Page
Loading...
