APG PG-7 - Table of Contents; Warranty

PG7 Rev. A2, 07/16
2
Automation Products Group, Inc.
Table of Contents
Warranty ............................................................................................................ 3
Programming the PG7 ................................................................................. 4-23
Full Access Menu ............................................................................................ 5
Accessing the Mode Setting........................................................................... 6
 ModeDenitions ............................................................................................ 6
Accessing/Exiting the Setup Menu ................................................................ 7
Maximum/Minimum Reset ........................................................................... 8
Units of Measure ............................................................................................ 9
Using Custom Units ............................................................................... 10
Peak-Hold Feature ....................................................................................... 11
Advanced Settings ................................................................................... 12-17
 Auto-O .................................................................................................. 12
Decimal Place......................................................................................... 13
Sample Rate ........................................................................................... 14
Bar Graph ............................................................................................... 15
Range Adjustment ................................................................................. 16
Quick Calibration................................................................................... 17
Tare Feature ................................................................................................. 18
Default .......................................................................................................... 19
Output ...................................................................................................... 20-24
Setting/Calibrating Analog Signal Span/End-Points ......................20-21
Trip Points ..........................................................................................22-24
Wiring ..........................................................................................................25-26
Specications ..............................................................................................27-28
Declaration of Conformity ........................................................................29-30
www. .com
information@itm.com1.800.561.8187