E6 44 DTR.APC.APR.ALW.03(ENG)
The selected unit should be confirmed by pressing [◙].
After approval the parameter transmitter will confirm the party of command by the "DONE" or report the error
number. The "← BACK" cause goes up one level.
Descriptions:
Return from the local Menu to the normal operation of the transmitter
Setting the lower range of values set by the done pressure
(no change of span)
Set across inscribing of value (after approval at display the current
value will appear before the passage in edit mode)
Select and confirm sign introduced parameter. Introduce in sequence,
digit after digit, 5 digital numbers with point or without point. After
confirmation the last 5 digit of the parameter transmitter will confirm
the party of command by the "DONE" announcement or the proper
number of error will notify. The parameter will be written down in units
"UNIT".
Set the upper range value by the done pressure
Menu process variable units
inches of water at a temperature of 68° Fahrenheit
inches of mercury at a temperature of 68° Fahrenheit
Foot of water a temperature of 68° Fahrenheit
mm of water at a temperature of 68° Fahrenheit
grams per square centimetres
kilogram per square centimetres, technical atmosphere
inch of water at a temperature of 4ºC
set of the solid temporary suppression of the process variable
set of the current output form
Square root characteristic cut-of point setting
Assigning a process variable to LCD1
On LCD1 will displayed current value in current loop in [mA]
The percent value output signal will displayed on LCD1- controlling
in%
Assigning a process variable to LCD2
The pressure value will displayed on LCD2
The user’s units will be displayed on LCD2. Scaling of the user range
and record of the user units can be made using a computer or
communicator, see → HART command No. 244.245.
The current temperature of pressure sensor will displayed on LCD2
The current temperature of the transmitter CPU will displayed on
LCD2 - in ºC
To Next Page
Loading...
Need help?
General
