15
Apogee Ensemble Thunderbolt | User’s Guide
Update Ensemble Firmware
The rst time Ensemble is used after the software installation, you
will likely receive a prompt to update the rmware.
Warning: Do not disconnect power or interrupt the rmware
update process before it is complete as this may damage the unit.
1� Make sure Ensemble is connected to the computer and is
powered on� Make sure only one Apogee device is connected�
2� If a prompt does not appear, manually open the Apogee
Firmware Updater�app which is located in the Mac’s
Applications > Utilities folder�
3� Select “Start Update”�
Follow any prompts that may appear�
Note: You may be asked to unplug and reconnect the
Thunderbolt cable more than once.
4� When complete, the Hardware & Updater versions will
match, and you can quit the updater�
To Next Page
Loading...
