Apogee Ensemble Thunderbolt - Out View Controls; Output Trim and Source Selection

49
Apogee Ensemble Thunderbolt | User’s Guide
Out View
The Out View of the Primary Window shows the settings and level meters for the analog and digital outputs�
1. Hardware Output Label - Indicates the analog or digital hardware output�
2. Output Channel Level Meter - Shows the digital signal level before the D/A conversion�
3. Output Icon - Indicates which output’s volume level is controlled by the Main Output volume control, and which are
xed-volume line-level outputs.
4. Analog Level - Set the output level for each analog channel� Match this level with the analog gear to which Ensemble is
connected�
• Choose +4dBu when connecting to professional line level equipment�
• Choose -10dBV when connecting to “semi-pro”, hi-, or consumer equipment.
5. Output Trim Control - Use to adjust the analog output stage for precise calibration between speakers (see page 37)�
• Option+click to reset to 0� Command+click to reset all channels to 0�
6. Hardware Output Source - Set the signal source for the pair of hardware analog or digital outputs�
• Choose a Playback source to route audio directly from your DAW�
• Choose a Mixer source to route audio from a Symphony Control mixer�
• Choose a Hardware Input source to route audio directly from an I/O Module input�