EasyManua.ls Logo

Apogee Ensemble Thunderbolt - System Sidebar Settings; System Status and Master Device; Clock Source and Sample Rate; Talkback Source and Destination

Apogee Ensemble Thunderbolt
67 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
43
Apogee Ensemble Thunderbolt | User’s Guide
System Sidebar
Provides System-wide settings that apply to your recording system as a whole�
1. System Status Display - Displays the status of the connected hardware�
Green - System is ready: hardware is connected and recognized, and the digital clock is
locked to the Clock Source
Red - System is not ready� Either the hardware is not connected or the system is not
locked to the Clock Source
2. Master Device - When two Ensembles, or an Ensemble & Element are connected, select
one as the Master Device� The Master Device acts as the clock master
3. Clock Source - Selects the system clock source� The Following sources may be selected:
Internal: Ensemble is clocked from its internal crystal
Word Clock: Ensemble is clocked from an external word clock signal connected to the
rear panel BNC input
SPDIF Coax: Ensemble is clocked from a Coax digital audio input
SPDIF Optical 1-2 or 3-4: Ensemble is clocked from a SPDIF optical digital audio input
ADAT 1-8 or 9-16: (Only sample rates 44�1 & 48k) Ensemble is clocked from an ADAT
optical digital audio input
SMUX 1-4 or 5-8: (Only sample rates 88�2 & 96k) Ensemble is clocked from an SMUX
optical digital audio input
Note: ADAT & SMUX not available when in Multi-Mode.
4. Sample Rate - Sets the Ensemble system Sample Rate� In some cases this setting may be
overridden by software running on the computer (i�e� When a DAW session project is open)�
Note: Multi-Mode has a max Sample Rate of 96k.
5. Peak Hold - Sets the time that peak indications are held on the level meters�
6. Over Hold - Sets the time that over indicators are held on the level meters�
7. Talkback Source - Select the source of the Talkback Signal� If your Mac is equipped with a
Built-in Mic, select Built-in Mic as the source�
8. Talkback Destination - Talkback signal is sent to the selected Playback channel�
9. Keyboard Volume - The audio system may be congured so that the Mac keyboard
volume controls set the output level of Element’s Main or Headphone outputs�

Table of Contents

Related product manuals