53
Apogee Ensemble Thunderbolt | User’s Guide
The following functions apply to the Assignable Buttons on
Ensemble’s front panel
None - When a button is assigned to None, it does nothing�
Mute Speaker - Mute the Main speaker output�
Mute Headphones 1, 2 - Mute the Headphones output�
Mute All Outputs - Mute the Main and all Headphone outputs; tap again to unmute�
Mute Toggle Headphone/Speaker - Toggle between two states:
1� All Headphone outputs muted and the Main speaker output unmuted�
2� All Headphone outputs unmuted and the Main speaker output muted�
- When recording in the same room as speakers, this function provides one button
switching between recording with headphones and listening back over speakers�
Dim Speakers - Lower the output volume of the Main speaker output by -15dB� This function
is convenient for briey lowering the playback volume without completely
muting the output�
Dim Headphone 1, 2 - Lower the output volume of the Headphones by -15dB� This function
is convenient for briey lowering the playback volume without completely
muting the output�
Dim All Outputs - Low the output volume of the Main and Headphones -15dB� This function
is convenient for briey lowering the playback volume without completely
muting the output�
Mono Speakers - This function is used to examine phase relationships on stereo tracks� When engaged, the left and right
Main speaker signals are combined and phase errors between the two become more noticeable�
Mono Headphone 1, 2 - This function is used to examine phase relationships on stereo tracks� When engaged, the left and
right Headphones signals are combined and phase errors between the two become more noticeable�
Mono All Outputs - The left and right output signals of both Main and Headphones are combined�
Engage Speaker Set A, B, C - Engage a particular speaker set when a front panel Assignable Button is pressed� Note this
only works when the Main Output Format is set to either “2 Speaker Sets” or “3 Speaker Sets”�
Toggle Speaker Set A/B - Toggles between engaging Speaker set 1 or 2� Note this only works when the Main Output Format
is set to either “2 Speaker Sets” or “3 Speaker Sets”�
Clear Meters - Removes any peak and over indicators on the level meters�
Engage Talkback - When selected, the assignable button must be held down to engage talkback�
Toggle Guitar 1 Out THRU/SW - When selected, the Assignable button will change the Guitar 1 Output source between
THRU operation and FROM SOFTWARE operation�
Toggle Guitar 2 Out THRU/SW - When selected, the Assignable button will change the Guitar 2 Output source between
THRU operation and FROM SOFTWARE operation�
Toggle All Guitar Outputs THRU/SW - When selected, the Assignable button will change both the Guitar 1 & 2 Output
source between THRU operation and FROM SOFTWARE operation�
To Next Page
Loading...
