Apogee Ensemble Thunderbolt - Choosing the Talkback Destination; To Select the Talkback Destination; Setting an Assignable Button to Activate Talkback; Setting a Button on the Control Hardware Remote for Talkback

35
Apogee Ensemble Thunderbolt | User’s Guide
Choosing the Talkback Destination
The Talkback can be sent to any Playback channel� From there it can be sent directly to the headphone or main
outputs, or can be directed through any of the Mixers rst.
To select the Talkback Destination:
1� Open Apogee Control and click the System
button to reveal the system sidebar�
2� Under Talkback Destination, select your desired
Playback Channel�
Setting an Assignable Button to activate Talkback
From the factory, assignable button A on Ensemble’s Front Panel is programmed to activate Talkback� However,
any of the Assignable buttons can be set to this function:
1� Open the Remote window in the Apogee Control software�
2� Under the Front Panel Assignments section, click the
button under A, B, C, or D and select “Engage Talkback”�
3� The Talkback function is on while the Assignable button
is held down (momentary)�
Setting a button on the Control hardware remote for Talkback
1� Open the Remote window in the Apogee Control software�
2� Under the Remote Control Assignments Section, click under the desired button and from the menu that appears,
choose a Talkback option:
• Momentary Talkback
- The button must be held down to maintain talkback�
• Toggle Talkback
- Press once to turn Talkback on�
- A second press turns Talkback o.