Apogee Ensemble Thunderbolt - Front Panel & Remote Control Assignments; Remote Control Assignment Functions; Front Panel Assignable Button Functions; Speaker Set and Talkback Assignments

51
Apogee Ensemble Thunderbolt | User’s Guide
Front Panel & Remote Control Assignments Window
The Front Panel & Remote Control Assignments Window provides settings to congure the optional Apogee
Control hardware remote control, as well as the four Assignable buttons on Ensemble’s front panel� To open this
window choose Window > Remote, type Command+4, or click on the Remote toolbar button�
The nine buttons at the top of the window - 1-4, A-D and Control Knob - are used
to dene the function of the Remote’s hardware function buttons. Click any button
to reveal a menu of assignments�
The four buttons at the bottom of the window - A-D - are used to dene the
function of the Assignable buttons on Ensemble’s front panel� Click any button to
reveal a menu of assignments�
The following functions apply to the Remote control device.
None - When a button is assigned to None, it does nothing�
Mute Panic - Mute the Headphones and Main outputs of all connected units�
- Tapping the button again doesn’t un-mute the signal - it must be un-muted
in Apogee Control software�
Mute Speakers - Mute the Main speaker output�
Mute Headphones - Mute the Headphone outputs of all connected interfaces�
Mute All Outputs - Mute the Main and all Headphone outputs; tap again to unmute�
Mute Toggle Headphone/Speaker - Toggle between two states:
1� All Headphone outputs muted and the Main speaker output unmuted�
2� All Headphone outputs unmuted and the Main speaker output muted�
- When recording in the same room as speakers, this function provides one button
switching between recording with headphones and listening back over speakers�
Dim Speakers - Lower the Main speaker output by -15dB�
Dim Headphones - Lower the Headphone outputs of all connected interfaces by -15dB�
Dim All Outputs - Lower the Main and all Headphone outputs by -15dB�
Mono Speakers - Sum the stereo Main speaker output to mono (when two interfaces are
connected, Master interface only)�
Mono Headphones - Sum the Headphone outputs of all connected interfaces to mono�
Mono All Outputs - Dim the Main and all Headphone outputs�
Toggle Speaker Sets - When Main Output Format (Device sidebar) is set to 2 or 3 Speaker Sets,
this will cycle playback to the next speaker set with each button press�
Select Speaker Set 1, 2, 3 - The Main output will jump immediately to the selected speaker set�
Only applies when Main Output Format is set to 2 or 3 speakers sets�