Sync Signal = indicates the Synch signal that is programmed into the instrument.
Sync Signal Mode: indicates the Sync signal mode that can be programmed into
the instrument.
The Synch Signal Modes available are OFF, ON, EVENT, and FREQ. Press the
Change soft key to toggle the mode. To save the parameter, press the Enter soft
key. To cancel the editing of the Sync Signal Mode, press the Esc soft key. When
the Enter soft key is pressed the Sync Signal Mode is accepted and you
transition into the next system parameter: Auto Run.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
4.3.18 Editing Function (Option 08 only)
Use the , soft keys to navigate to the Function parameter. Pressing the Edit
soft key will provide the following screen:
Function = indicates the Link Function mode for operating two instruments in a
master-slave configuration.
Link Function Mode: indicates the Link Function mode that can be programmed
into the instrument.
The Link Function Modes available are Parallel and 1Φ3W (two interconnected
To Next Page
Loading...
Need help?
General
