20
Parallel
Stand-alone running mode
Single-phase parallel mode
Note: This setting is only available when
the inverter is in standby mode (Switch
off).
Three Phase:
1.if users need three-phase parallel ,each
device must be set to A/B/C separately.
2.Three-phase parallel needs at least
three device to do three-phase parallel
run.
3.when three-phase parallel,make sure
that A-phase is the host;
4.after the parallel parameters are
modified,the device must be
restarted to be effective;
5. All inverters must share the same
battery pack when paralleling
6.This setting is only available when the
inverter is in standby mode (Switch off).
Date & Time
You can set the local date and time in your
country
Grid
OnGrid: disable(default)
To Next Page
Loading...
