What to do if Aptiv Automobile Accessories charging process is interrupted due to increased temperature in the power plug?
If your Aptiv Automobile Accessories charging process is interrupted due to increased temperature in the power plug, you should check the grid socket or protect the IC-CPD charging equipment from direct sunlight.
What to do if Aptiv Automobile Accessories charging interruption due to increased temperature of the ICCB?
If the charging process of your Aptiv Automobile Accessories is interrupted because the ICCB temperature has increased, examine the grid socket or shield the IC-CPD charging equipment from direct sunlight.
What to do if Aptiv IC-CPD FAULT LED flashes continuously red?
If the FAULT LED on your Aptiv Automobile Accessories flashes continuously red after or during the charging process, you should not use the device.
How to fix Aptiv IC-CPD FAULT LED flashing three times?
If the FAULT LED flashes three times on your Aptiv Automobile Accessories, followed by a short break: - Remove the power plug from the socket. - Wait for approximately 5 seconds. - Carefully re-insert the power plug into the socket.
Explains the meaning and severity of DANGER, WARNING, and CAUTION indicators used in the manual.
Illustrates various prohibitions and instructions for safe handling and operation of the charging equipment.
Details risks associated with electric shock and fire, including proper grounding and socket usage.
Outlines precautions to prevent explosions and fires, especially in potentially explosive environments.
Provides instructions on protecting the device from damage and defines its intended operational use.
Provides a sequential guide on how to operate the IC-CPD charging equipment for vehicle charging.
Guides users on diagnosing issues indicated by the FAULT LED and rectifying them.
Provides instructions on safe cleaning and cautions against using specific agents.
General| Category | Automobile Accessories |
|---|---|
| Manufacturer | Aptiv |
| Charging Mode | Mode 2 |
| Connector Type (Vehicle Side) | Type 2 |
| Operating Temperature | -30°C to +50°C |
| Storage Temperature | -40°C to +80°C |
| Cable Length | 5m |
| IP Rating | IP67 |
| Input Voltage | 230V AC |
| Output Voltage | 230V AC |
| Product Type | IC-CPD (In-Cable Control and Protection Device) |
| Protection | Overcurrent, Overvoltage, Short Circuit, Over Temperature |
| Output Current | 16A |
| Charging Power | 2.3kW or 3.7kW |
| Dimensions | 200mm x 100mm x 50mm |
To Next Page