Aqualisa MIDAS 110 - Midas Shower Column Installation; Shower Column Preparation

19
UK
Shower head attachment
MIDAS
SHOWER COLUMN
In addition to the guide below it is essential that the written instructions are read and
understood and that you have all the necessary components before commencing installation.
Failure to install the product in accordance with these instructions may adversely aect the
warranty terms and conditions. Do not undertake any part of this installation unless you are
competent to do so. Prior to starting ensure that you are familiar with the necessary plumbing
regulations required to install the product correctly and safely.
The BAR001FIX bar valve fixing kit provided with Midas
110/220 shower column provides a method of surface siting
exposed bar valves onto a finished wall surface, using
15mm concealed pipe work.
If required, fit the bar valve fixing accessory following the relevant installation instructions
provided and proceed to step 6.
The valve and fixing bracket assembly MUST NOT be used as a grab rail support method.
INSTALLATION INSTRUCTIONS
SHOWER COLUMN PREPARATION
Prior to commencing, measurements must be made in preparation for fitting the
shower column. Ensure that the shower will be in a comfortable position for all users
and the shower column fits within the height restrictions of the proposed siting. A
minimum clearance of 1.2m* is required.
*Measured from the top of the bar valve to the top of the arm.
The maximum height for the handset holder is limited to the bottom of the
rail bracket.