15
8
Pass the rail through the handset holder whilst keeping the slider levers depressed with the
handset holder pointing in a downward direction
9
Carefully slide the gel hook onto the rail under the handset holder.
10
Current water supply regulations state the handset should not be allowed to pass a point 25mm above the spill over level
of the bath or shower tray. If this cannot be achieved, the hose must be passed through the gel hook which has also been
designed to be utilised as a hose restraint.
11
Fit the rail into the rail end bodies taking care to engage the location slot onto the lugs.
12
Fit the rail end clip fitting into position into the top rail end body. Secure the rail assembly to wall
using the screws provided ensuring the rail and rail end bodies remain firmly engaged.
13
Place the rail end covers into position and push firmly into place.
14
Connect the hose to the wall outlet or valve outlet, ensuring the hose washer is correctly fitted,
to allow the water to discharge safely to waste and run the shower for a few seconds to clear any
debris in the outlet assembly.
To Next Page