22 - 60
IsACQ110C-0 (ENG) Rev.230708-0
The programs that can be set using Aquarium Controller have priority over the others
based on the table below, in which they are listed with decreasing priority.
Program priority
1 Water leakage sensor program
2 Manual commands
3 Blackout
4 Function key
5 Function key
6 Function key
7 Function key
8 Sequences Program
9 Level sensor program
10 High conductivity (density) sensor program
11 Low conductivity sensor program
12 Temperature sensor program
13 pH sensor program
14 Redox sensor program
15 Summer function
16 Wave effect
17 Tide effect
18 Program timer
Note:
the programs have varying priorities depending on the sensors involved in the
program. The priority will be one position higher than the highest of the sensors included
in the variables.
For example, an XY program that has a pH and a Density as variables will have a priority
falling between density and level.
To Next Page
Loading...