Aquatronica evolution ACQ110 - Temperature Menu; Temperature; Change Name

44 - 60
IsACQ110C-0 (ENG) Rev.230708-0
Temperature Menu
Temperature (Fig. 56)
Inthismenuitispossibletocarryoutallthesettingsrelevant
to the temperature of the water.
Allthemenusrelevanttothismeasurementareenabledonly
when the temperature sensor is connected to the system.
When the temperature sensor is connected, the control unit
willdisplayaplug-inscreenwhereitispossible,ifwanted,to
changethenameoftheconnectedsensor(Fig.55).
Press “Enter” to accept. The control unit is already equip-
pedtoreadanddisplaythetemperature(withthesupplied
sensor).
Moreover,itispossible:
-tomodifythestateoftheplugsdependingonthetempe-
raturereadings;
-tosetthedesiredvalue;
-todisplaytheprogressoverthelast24hours;
-tosetacousticalarms;
- to calibrate the sensor in relation to the position in which
itisplacedoralignitwithanothertraditionalsensoralready
presentintheaquarium;
- to set the unit of measurement of the temperature.
To set these functions, proceed as follows:
Main screen  Main Menu  Temperature.
Change Name (Fig. 57)
Modiesthenamegiventothesensor.
To modify the name, proceed as follows:
Main screen  Main Menu  Temperature  Change
Name.
•Selectthelettersbyusingthekeys whileusingkeys
 to move within the word. When nished, press “En-
ter”.
(Fig. 56)
Temperature
Change Name
Programs
Data Record
Alarm
Calibrate Sensor
(Fig. 57)
Temperature
(Fig. 55)
New device connected
S01
Temperature