Aquatronica evolution ACQ110 - Blackout; Unlock All

34 - 60
IsACQ110C-0 (ENG) Rev.230708-0
Power Unit Menu
BLACKOUT
This function allows you to select which outlets you want to
staydisabledwhenthepowersupplyisrestored(afterthere
hasbeenablackoutwhichlastsforlongerthanthetimeset
bytheuser)untiltheyareautomaticallyre-enabledaftera
programmabletime(Fig.44).
To assign a blackoutfunction to an outlet, proceed as fol-
lows:
Main screen  Main menu  Power unit  Select
power unit  Blackout  Select outlet
•Set the type of programtoYES.(If it is left on NO,the
programwillnotbevalid).
•Setthe Blackoutdurationtimeafterwhich the controller
willautomaticallylocktheoutlet(Fig.45).
•Set a delay time, that is a time during which the outlet
staysdisabledafterthepowersupplyhasbeenrestored(Fig.
45).
Unblock All (Fig. 46)
Thisunblocksallthedeactivatedoutputssimultaneouslywhen
apoweroutagehasoccurredforover an hour.
NOTE: this function is activated only if the power has
been interrupted for more than an hour.
To carry out this function, proceed as follows:
Main screen  Main Menu  Power Unit  Power Cut 
Unblock All.
•Theunblockingscreenappears(Fig.46).Press“Enter” to
unblockor“Esc” to cancel.
A A
B B
C C
D D
E E
(Fig. 44)
(Fig. 45)
Outlets
Blackout
Duration: Øh5m10s
Delay: Øh5m10s
Active: YES
(Fig. 46)
Would you like to
unblock all the outputs?
Enter: Conrm
Esc: Cancel