Page 9
71423 56 8
CHANNEL
71 423 56 8
4. Function Settings
A. TRANSMITTER HANDSET
1. System Channel Settings
(Fig. 07)
Set the transmitter channel by adjusting the channel dip-switch located on the backside of the
transmitter encoder board (refer to Fig. 07 above). Only the first six (6) positions are used for channel
programming (refer to Fig. 08 below). The system channels table located on page 24 illustrates which
dip-switch setting corresponds to which channel. Once the transmitter channel is altered do make sure
to change receiver channel as well. The channel on both transmitter and receiver must be identical in
order for system to work. To change receiver channel please refer to page 17.
Example: Top slot → “1”
(Fig. 08) Bottom slot → “0”
The above dip-switch setting “1 0 0 1 0 0” corresponds to “channel 36” in the system channels table
on page 24.
To Next Page
Loading...
