Page 30
1
2
4. Automatic Channel Scanning Operating Procedure
After changing transmitter channel (refer to page 9), turn on the transmitter power and rotate the
power key switch to “Start” position and hold it there for up to 1.0 minute. Within this 1-minute period
the receiver will search (channel 01 ~ channel 62) and lock onto the newly selected transmitter
channel automatically. Please note that in order for the receiver to switch to auto-scanning mode, prior
to changing the transmitter channel, you must first deactivate the receiver MAIN by shutting off the
transmitter power or press down the emergency stop button. Please refer to page 19 if you do not want
the receiver to auto-scan all 62 channels.
Change Transmitter Channel →
5. Changing Transmitter Batteries
Changing transmitter batteries by unscrewing the battery cover located on the backside of the
transmitter (refer to Fig. 20 below). During battery installations make sure that the blue ribbon is
centered between the two batteries. After changing the batteries also make sure that all screws are
tightened to avoid water, moisture, dirt, grease, or other liquid penetration.
(Fig. 20)
↓
To Next Page
Loading...
