EasyManua.ls Logo

ARC Flex Series - I-Chip Functionality

ARC Flex Series
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 15
4. Program 4-digit Security Code
Prior to rotating the transmitter power key-switch to START position to begin operation, you must first
enter a 4-digit security code in order to proceed further. When this 4-digit security code is input
correctly, a green light will appear on the Status LED. Please refer to the instruction below on how to
program the 4-digit security code.
a. Press and hold PB1, PB2, PB3 and PB4 and rotate the power key to START position at the same
time.
+
b. A constant orange light will appear on the Status LED telling you that you are in the security
code programming mode.
c. For newly purchased system with the security code function deactivated (default setting), press
PB1 four times (1111) to activate the security code function. At this time the Status LED on the
transmitter will blink orange slowly telling you that the 4 digits entered is correct. Then select
your own 4-digit security code by pressing PB1, PB2, PB3 or PB4 on the transmitter (four
presses randomly). At this time a fast orange blinks is displayed on the Status LED telling you to
reconfirm the 4-digit security code you have just entered. A green light will appear once you
have re-entered the same 4-digit security code again (programming completed). If red light is
shown on the Status LED after you have re-entered the security code (incorrect input), then you
must reset the transmitter power and then repeat step a, b and c again.
Steps: Press and hold PB1~PB4 and rotate power key to START position constant orange
press PB1 four times (for new systems) or 4-digit security code slow orange blinks enter
the new 4-digit security code fast orange blinks re-enter the same 4-didgit security code
again green light.
d. If you wish to cancel the security code function, then repeat a, b, c above and press PB1 four
times as your new security code (security code function disabled).
e. If you do not remember the 4-digit security code, then you must contact your dealer or
distributor for further assistance.

Table of Contents

Related product manuals