Page 18
ON
OFF
OFF
Aux
STOP
2. Auxiliary Functions
a. ON/OFF Push Button Function
The user can set any of the two adjacent push buttons on the transmitter to behave like a
mechanical ON & OFF rocker switch (refer to page 20 on how to set to this function).
When “On” output relay is closed (“On” push button pressed), the “Off” output relay will
open automatically, or vise versa.
b. Magnet ON/OFF Push Button Function
The user can set any of the two adjacent push buttons on the transmitter to control a magnet.
To activate the magnet just press the push button with the Magnet symbol. To deactivate the
magnet, for safety purpose, you must first press and hold the Magnet push button and then
press the OFF push button. Press the OFF push button by itself can not deactivate the magnet
(refer to page 20 on how to set to this function).
c. External Warning Function
The user can install an external warning device (rotating lights, horn, etc…) to a special
“Function output relay” located inside the receiver. The user can choose which push button
pairs or crane motions he desired to have external warnings when push button is pressed
(refer to page 20 on how to set to this function).
d. Auxiliary STOP Push Button Function
The auxiliary STOP function acts as a 2
nd
emergency stop button. Other than by emergency
stop button and transmitter power key switch, the receiver MAIN is also deactivated when
this auxiliary stop push button is pressed (refer to page 21 on how to set to this function).
e. Momentary Contact
When push button is released the output relay corresponds to that push button will open (refer
to page 21 on how to set to this function). This type of contact is usually applies to external
application such as horns or buzzers.
To Next Page
Loading...
