Page 12
C. Inline Push Button Configuration (Transmitter Toggle)
The push button arrangement for inline push button setup starts from top to bottom and then
from right column to left column (refer to Fig. 10 below). To set inline push button
configuration please refer to JP4 and JP5 jumpers setting on page 22. With inline push
buttons configuration, PB1 & PB2 still corresponds to output relay K1~K2, PB3 & PB4
corresponds to relay K5~K6, etc…
(Fig. 10)
DIP PB5 PB6 PB7 PB8
24
00000000 Normal Normal Normal Normal
25
00000101 Normal Normal Normal LED 4
26
00010100 Normal Normal LED 3 LED 4
27
00010101 Normal LED 2 LED 3 LED 4
28
00010110 LED 1 LED 2 LED 3 LED 4
* PB5…PB8 → Push button number
* Normal → Normal momentary contact
* LED 1…LED 4 → Transmitter toggled with designated LED Display
To Next Page
Loading...
