ARC Flex Series - Jumper Settings; Jumper Settings Overview

Page 22
JP7 JP1 JP5 JP3 JP2 JP4 JP6
5. Jumper Settings
Jumper settings are applied to functions such as mainline-disconnect time, Start function,
transmitter push button layout, system information (serial number/ID code) programming and
system testing. The jumpers #1 ~ #7 are located on the decoder module above the six (6)
dip-switches (refer to Fig.16 below).
(Fig. 16)
▇ Manufacture preset
Jumper Settings Function
JP1
(Blank)
JP2
(Blank)
Receiver MAIN remained closed unless the transmitter power is turned
off or emergency stop command is initiated.
JP1
(Inserted)
JP2
(Blank)
Receiver MAIN opens after 5 minutes of inactivity.
JP1
(Blank)
JP2
(Inserted)
Receiver MAIN opens after 30 minutes of inactivity.
JP1
(Inserted)
JP2
(Inserted)
Receiver MAIN opens after 60 minutes of inactivity.
JP3
(Blank)
After turning on the transmitter power key switch or after resetting the
emergency stop button, press any push button to activate the receiver MAIN.
JP3
(Inserted)
After turning on the transmitter power key switch or after resetting the
emergency stop button, rotate the power key to “START” position to activate
the receiver MAIN.
JP4
(Blank)
JP5
(Blank)
Standard right-to-left push button configuration for all models.
JP4
(Inserted)
JP5
(Blank)
In-line push button configuration (top to bottom) for FLEX 8ES/EX.
JP4
(Blank)
JP5
(Inserted)
In-line push button configuration (top to bottom) for FLEX 12ES/EX.
JP4
(Inserted)
JP5
(Inserted)
In-line push button configuration (top to bottom) for FLEX 4ES/EX.
JP6
(Blank)
Program system serial number/ID code and channel from decoder module
to I-CHIP.
JP6
(Inserted)
Program system serial number/ID code and channel from I-CHIP
to decoder module.
JP7
(Inserted)
For system test only, receiver MAIN disabled.