ARC Flex Series - Push Button Functions with LED Displays; Standard Push Button Configuration (Transmitter Toggle)

Page 10
52134 867
FUNCTION
LED 1LED 2LED 3LED 4
2. Push Button Functions with LED Displays
A. Standard Push Button Configuration (Transmitter Toggle)
Set transmitter toggle (latching output relay) function by adjusting the 8-position function
dip-switch located on the backside of the transmitter encoder board (refer to Fig. 09 below).
The LED 1 through LED 4 shown inside the shaded box (see below) illustrates which LED on
the transmitter will light up when the designated push button (PB5 ~ PB8) is pressed.
(Fig. 09)
DIP PB5 PB6 PB7 PB8
1
00000000 Normal Normal Normal Normal
2
00000101 Normal Normal Normal LED 4
3
00000110 Normal Normal LED 3 LED 4
4
00000111 Normal LED 2 LED 3 LED 4
5
00001000 LED 1 LED 2 LED 3 LED 4
* PB5…PB8 → Push button number
* Normal → Normal momentary contact
* LED 1…LED 4 → Transmitter toggled with designated LED Display