Page 25
6. Receiver Installation
A. OUTPUT RELAY CONTACT DIAGRAM
* If the transmitter’s push button #7 is programmed with Select A/B function (refer to page 11 & 13)
then “Select A” position shall be connected to “FWD” output relay (wire #19) and “Select B” position
connected to “AUX-1” (wire #21). If push button #8 is programmed with Select A/B function, then
“Select A” position shall be connected to “REV” output relay (wire #20) and “Select B” position
connected to “AUX-2” (wire #22).
* For different voltage settings please refer to page 23.
* For F9 and F10 power fuse ratings please refer to page 23.
* For 9~36VDC power supply, wire #1 corresponds to the negative charge (-) and wire #3 corresponds
to the positive charge (+), wire #2 is for GROUND.
To Next Page
Loading...
