Arcam SA10 - Rear Panel Connections and Outputs; Rear Panel Interface Overview

EN-8
Rear Panel Connections and Controls
POWER INLET
110-120V/220-240V ~ 50/60Hz
SUPPLY
VOLTAGE
SWITCH POSITIONS
115 = 110 - 120V ~
230 = 220 - 240V ~
RS232NET USB
5V 100mA
SAT
AV
BD
R
L
CD PVR STB
PRE
OUT
PHONO
(MM)
4-16 OHMS
R
L
CLASS 2 WIRING
DIGITAL IN
ANALOGUE IN
POWER INLET
Connect the correct
mains cable here
USB
This USB socket is used for software
upgrades only
See “USB Connection” on page EN-9
VOLTAGE SELECT
Ensure that the voltage selected
matches the local power supply
PRE-AMPLIFIER OUTPUT
Provides the pre-amplifier output for use
in a bi-amplified system.
See “Pre-Amplifier Output” on page EN-10
PHONO GROUND CONNECTION
Connect the turntable earth lead, if required
Note that this terminal must not be
used as a safety earth
DIGITAL AUDIO INPUTS
Optical and coaxial digital audio
connectors
See “Digital Audio Inputs” on page EN-10
ANALOGUE AUDIO INPUTS
Phono (MM) and line level audio inputs
See “Phono Input” on page EN-10 and “Analogue
Audio Inputs” on page EN-10
NETWORK
Connect this socket to a port on your network
router using an Ethernet patch cable
See “Network Connection” on page EN-9
RS232
This connection allows for remote control
from a third-party home automation system or
computer
See “RS232 Connection” on page EN-9
SPEAKER TERMINALS
See “Loudspeakers” on page EN-11
SA10
SA20
POWER INLET
110-120V/220-240V ~ 50/60Hz
XXkW MAX
SUPPLY
VOLTAGE
SWITCH POSITIONS
115 = 110 - 120V ~
230 = 220 - 240V ~
RS232NET USB
5V 100mA
SAT
AV
BD
R
L
CD PVR STB
PRE
OUT
4-16 OHMS
CLASS 2
WIRING
R
L
DIGITAL IN
ANALOGUE IN
PHONO
(MM)
Please read the sections “Placing The Unit”, “Power” and
“Interconnect Cables” on page EN-6 before connecting
your SA10/SA20 amplier!