The remote control is pre-programmed for use with the
SA10/SA20 amplifier and also an Arcam CD player. The
information in this section applies to the AMP section
of the remote control only.
Make sure the two AAA batteries (supplied) are installed
before attempting to use the remote control.
1. With the remote face down, press down on the non-
slip indentations of the battery compartment cover
and slide the cover off
Toggles power between standby and
powered on
Cycles through the front panel display
brightness options
Toggles the mute function of the amplifier
Increase/decrease amplifier volume
BAL
Adjust the balance of the left channel
BAL
Adjust the balance of the right channel
PHONO
Select the PHONO (MM) input
CD
Select the CD analogue input
BD
Select the BD coaxial digital input
SAT
Select the SAT optical digital input
PVR
Select the PVR analogue input
AV
Select the AV coaxial digital input
AUX
Select the 3.5mm socket analogue input
(located on the front panel)
STB
Select the STB analogue input
NOTE: The supplied remote control is designed to support both the SA10/SA20 integrated amplier as well as an
Arcam CD player. The section below applies to the AMP section of the remote control only. Refer to the CD user
manual for description on the CD section of the remote control unit.
2. Insert the two AAA batteries (supplied). Take care to
insert the batteries in the right direction by following
the ‘+’ and ‘-’ marks in the battery compartment
3. Slide the battery compartment cover back and lock
it in place with a click
The remote control requires a clear line of sight to
the front panel of the SA10/SA20 to ensure reliable
operation.
To Next Page
Loading...
