2-11
2
MD1419
4. Place a drain pan under the right-side belly pan
and position the pan in front of the chain case.
5. Locate and disconnect the air silencer drain hose
from the fitting at the bottom of the belly pan in
front of the chain case; then cut the cable tie that
secures the coolant drain hose to the engine
coolant hose on the timing cover side of the engine
compartment.
AO175
6. Using a suitable clamping device, pinch off the
coolant drain hose and remove the drain plug.
AO176
7. Using a length of ½ in. I.D. hose, slide it over the
end of the coolant drain hose; then attach the other
end to the air silencer drain hose fitting located in
the bottom of the belly pan.
AO177
8. Remove the radiator cap and install non-
pressurized Radiator Cap (p/n 0644-156).
AO178
9. Apply five to eight psi to the coolant system
through the coolant overflow tube and continue
until the coolant stops draining from the system.
AO179
10. On the Bearcat, remove the speedometer cable
from the speedometer; then cut the cable ties
securing the cable to the hood.
To Next Page