Spa Boy Owners Manual
1.15 Caring for your Spa Boy System
Spa Boy Maintenance
Question 3 How do I Care for the Spa Boy Sensor when Draining the Spas Water?
As the Spa Boy Sensor must always remain in contact with water, when the spas water is being drained the Spa Boy Sensor
Housing must be sealed before the water is drained.
The Spa Boy Sensor Housing is usually located in the foot well or other area of the spa that is not in the way of bathers or
impacted by water turbulence from jets. The Spa Boy Housing has a Grate screwed into the front of the Housing.
Steps for caring for your Spa Boy Sensor when draining the spas water:
• Find your 2” (50mm) Spa Boy Housing Plug that was installed in the Spa Boy Sensor Housing when your spa was first delivered.
• Check to ensure the Spa Boy Housing Plug has an O-ring in place, which is used to generate a seal between the plug and
housing when the plug is screwed into the housing.
• Turn the breaker off to isolate power to your Spa.
• Turning counter clockwise, unscrew the Grate located on the front of the Spa Boy Sensor Housing.
• Screw the Spa Boy Housing Plug provided with your spa into the front of the Spa Boy Sensor Housing. This will seal the
water
that is in the Housing and prevent the water in the Housing from draining when you drain your spas water.
Warning: The Spa Boy Sensor must never be permitted to freeze and must always remain in contact with
water. If the Sensor freezes or is not left in contact with water at all times the sensor will fail and will
require replacement! Such failures are not covered by warranty.
• You can now drain your spas water.
• Clean the Spa shell with a mixture of water and white vinegar. Rinse the shell down with fresh water and then polish the
shell with Arctic Pure, Reflection.
• When refilling your spa with water, leave the Spa Boy Sensor Plug secured in place until the water line is higher than the
Spa Boy Housing.
• The Spa Boy Housing Plug can now be unscrewed from the Housing and the Housing Grate can be screwed back into
the Housing.
• Once the water level has been reached the bottom of the pillow line you can turn the breaker back on to repower your spa.
71
To Next Page
Loading...
Need help?
General
