9.1 - Locate the registration code
Press and hold Pump 3 (or the Blower Button if still the old overlay) on the topside until the display says ‘rEG’ then
release. Enter the code displayed then press Continue.
The temperature can be adjusted using the + and - buttons or by moving the small circle around the loop.
• Press the Pump Control buttons to turn Pumps On and O.
• The EZ button will turn All Pumps On and O.
• Swipe the screen to the left and you will see the Spa Boy screen, if Spa Boy is installed in your spa
2020 Connecting the Linux Pack using Built-In WiFi
Owners Manual - OnSpa®
122122
Adjusting Temperature & Pumps
To Next Page
Loading...
Need help?
General
