Power Up
The in.k500 topside does not store the time and date. When the in.k500 starts up after a power loss a mes-
sage will prompt the user to reprogram the date and time.
NOTE: With the in.k500 equipped with a real time clock (RTC): If the power was lost for a few hours, this mes-
sage will not appear.
Setting Key
One press gives you access to a menu to manage the setting of your spa. Refer to the setting section for
details about the settings menu.
Audio Key (controls stereo)
The in.k500 can be used with the in.tune, in.stream or in.stream 2 audio systems. The Audio section in the
Settings menu of an in.stream gives you the option to disconnect or unpair your Bluetooth enabled device
when using the in.stream. With version 7.00 and higher, it is also possible to select Source to use a device
connected by auxiliary cable or Bluetooth wireless connection. The in.stream 2 Settings menu gives you a
Source selector, a Bluetooth disconnect option, an On/O switch and an audio control on fader, balance and
subwoofer. For more information on audio functions, see the in.tune, in.stream or in.stream 2 operation sec-
tion. The Audio option will only appear in the menu for keypads that are set up for an in.stream connection.
The in.stream 2 is automatically detected at power-up.
Power
Press any button to turn on the keypad. After 30 minutes without activity it will shut o.
Main Screen
The main screen gives you access to your accessories and water temperature. At the bottom of the screen,
you will see any error or maintain messages that are present.
Start or Stop Accessories
To start or stop an accessory, press the associated button. Icons will be animated when their accessory is
turned on, and inanimate when turned o. Icons on the screen will reect the speed or state of the devices
running on your spa. When an accessory has more than two states, press the button until it reaches the de-
sired state.
Water Temperature
The temperature shown at the top of the screen is the current wa-
ter temperature. Use the UP and DOWN buttons to set the desired
temperature. The set point will appear in blue at the bottom. After
3 seconds without any change to the set temperature value, the
keypad will resume the normal display of messages. When the set
value is lower than the current temperature Cooling to xx.x will ap-
pear. When the set value is higher than the current temperature.
Heating to xx.x will be indicated. Normally there is a short delay
before the heating starts, during which Heating Suspended is in-
dicated.
Topside functions
Owners Manual - Classic Series
4545
To Next Page
Loading...
Need help?
General
