A. Add sanitizers until levels are up to the recommended levels
B. Replace test kits at least once a year
C. Chlorine level very high and is bleaching test reagent, Allow sanitizer levels to recede by open-
ing cover and running jets.
A. Add Arctic Pure
®
Adjust Up until level reads 7.2 - 7.6 ppm
B. Add Arctic Pure
®
Refresh, add Boost.
C. Change from Bromine to Chlorine.
D. Drain and rell spa.
A. Check pH and adjust as required.
B. Shock with Arctic Pure
®
Refresh, add Boost.
C. Dilution of water will reduce contaminants and odor.
D. Check any ozone system is operational
A. Drain partially, add Arctic Pure
®
Best Defence, correct pH level to 7.2 - 7.6 and alkalinity to 100-
130 ppm.
A. Shock treatment with Arctic Pure
®
Refresh.
A. High concentration of oils and organics being agitated by the jets and/or
Therapy Air
A. Use Arctic Pure
®
Best Defence and have your dealer check your water balance
B. Add Arctic Pure
®
Boost treatment to raise chlorine levels and test chlorine levels.
C. Stop the use of fragrance
A. Dirty Filter. If you are using a pleated lter clean with Arctic Pure Filter Restore. If you are us-
ing a disposable lter you may need to change the lter for a fresh one. If you believe the lter is
ok then try increasing the ltration times via the topside control, app, or via the web portal at
myarcticspa.com
B. Add Arctic Pure
®
Easy Clear (Not with disponsable Filter)
C. Shock treatment with Arctic Pure
®
Refresh
D. Add Arctic Pure
®
Adjust Down until level reads 7.2-7.6
E. Add Arctic Pure
®
Adjust Down to adjust TA level to 80-120 ppm
F. Shock treatment with Arctic Pure
®
Refresh
G. Empty spa and rell
H. Add Arctic Pure
®
Best Defence until level reads 100-280 ppm
SOLUTIONS
2525
To Next Page
Loading...
Need help?
General
