29
8. Printing Configuration Report
1. Keep pressing the feed button while turning on the power, until
the printing motor has been activated.
2. After feeding 12-inch blank media, the printing motor will
suspend for one second, then it will print out the configuration
profile. This profile states the firmware version, ROM checksum,
RS232, thermal transfer/direct thermal settings, hardware
configuration and font types.
3. At PPLB emulation, the printer will enter character dump mode.
To exit from dump mode, just re-start the printer again.
30
9. Returning to Factory Default Settings
1. Turn on the printer and wait for 5 or more seconds.
2. Press the feed button for about 10 seconds, then the ready
indicator and the power indicator will go off in order.
3. While two indicators become lit again, release the feed button.
4. At this moment, the printer will feed the label stock 12 inches in
length, and come back to the factory default settings.
Note :
All settings are stored in non-volatile E2PROM and
cannot be destroyed even turn off the printer.
To Next Page
Loading...
