3.1.4 Acknowledge timeout
When you connect your scanner to your
cradle and start to scan bar codes, you might
wonder if your cradle receives bar code data.
Acknowledge timeout can help you confirm
data receipt.
When you turn on this feature, you’ll hear
two beeps after scanning a bar code. The first
beep is a good scan beep, the second beep
indicates that your cradle has notified your
scanner that data had been acknowledged.
Acknowledge timeout determines how long
your scanner waits your cradle to notify it.
You can only scan the next bar code after data
has been acknowledged. If you don’t wait the
second beep and keep scanning, you’ll hear
error beeps.
If timeout is set to 0, it is turned off. You can
keep scanning without waiting your cradle to
acknowledge data, but data might be lost if
you scan too fast.
To Next Page
Loading...
