vii
3.1.3 AIM symbology ID ................................... 26
3.1.4 Acknowledge timeout ............................. 27
3.1.5 Prefix and suffix ...................................... 29
3.2 Volume and vibration .................................... 30
3.2.1 Good scan beep duration ....................... 30
3.2.2 Inquiry beep (cradle only) ....................... 32
3.2.3 Scan volume ............................................ 33
3.2.4 Vibration ................................................. 35
3.2.5 Power on alert ........................................ 35
3.3 Operating mode ............................................ 36
3.3.1 Handcuff mode ....................................... 36
3.3.2 Batch mode ............................................. 37
3.3.3 Sleep mode ............................................. 38
Time to sleep (cradle ) ............................ 38
Time to sleep (mobile device) ................. 39
Sleep partial ............................................ 39
3.3.4 Auto-sensing mode ................................. 40
3.4 Interface selection (cradle only) .................... 40
3.4.1 HID setting .............................................. 41
Country (cradle only) .............................. 41
Caps Lock (cradle only) ........................... 45
Function key (cradle only) ....................... 45
Alphanumeric keys (cradle only) ............. 46
3.4.2 RS-232 settings ....................................... 48
Flow control (cradle only) ....................... 48
Response delay (cradle only) .................. 49
Baud (cradle only) ................................... 51
Parity check (cradle only) ........................ 51
3.5 Update firmware ........................................... 54
Install driver ............................................ 64
To Next Page
Loading...
