Resetting Printer to Factory Defaults
If you would like to reset the printer to its factory defaults
after certain commands have been sent or settings
changed:
1. Turn off the printer. Press and hold the CANCEL button.
2. Turn on the power.
3. Ribbon indicator blinks, release the button.
4. Ribbon indicator stops blinking and lights up.
5. The following parameters automatically reset.
- Label parameters
- Heat (Darkness)
- Speed
- Symbol set (language)
- Others for specific emulation
Notes :
1. All settings stored in non-volatile E
2
PROM cannot be destroyed
even by turning the printer off.
2. It is necessary to perform label sensitivity calibration after
resetting.
3. The printed label count can not be reset.
To Next Page
Loading...
