Ariens Compact 24 LE Service Guide

EN – 19
See Figure 28.
7. Remove hardware securing auger bushings to
housing.
See Figure 29.
8. Remove auger assembly from housing.
See Figure 30.
9. Remove bushing from auger shaft end.
10. Remove shear bolt from auger shaft.
11. Remove auger from auger shaft. Use of penetrating oil
or heat may be necessary to remove auger.
NOTICE: If rust is present on auger shaft, remove with
sand paper and wipe clean with oil.
Install Auger
See Figure 31.
1. Install auger onto auger shaft with auger kickers facing
gearcase.
IMPORTANT: Make sure auger helix direction matches the
original auger orientation.
2. Apply grease to grease zerk and spin auger by hand
to spread grease along auger shaft. Repeat.
Figure 28
1. Tapping Screw
2. Auger Bushing
1
2
Figure 29
Figure 30
1. Shear Bolt
2. Bushing
3. Auger
1
2
3
Figure 31
1. Auger Kicker
2. Gearcase
3. Grease Zerk
1
2
3

Ariens Compact 24 LE Specifications

General

Brand	Ariens
Model	Compact 24 LE
Category	Snow Blower
Language	English