EN – 26
BEARING FLANGE REPLACEMENT
Remove Bearing Flange
NOTICE: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Place unit in service position. See Service Position on
page 8.
4. For wheel models, remove axle lock pins securing
wheels to axle and remove wheels. See Figure 3.
NOTICE: For track models, it is not necessary to remove
tracks.
See Figure 43.
5. Remove hardware securing bearing flange to frame
and remove bearing flange.
Install Bearing Flange
1. Install bearing flange onto hex shaft end and secure to
frame with three tapping screws.
2. For wheel models, reinstall wheels onto axle and
secure with axle lock pins.
3. Return unit to operating position.
4. Reconnect spark plug wire.
CHUTE GEAR REPLACEMENT
Remove Pinion Gear
NOTICE: Save all hardware for reinstallation unless
specified otherwise.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
See Figure 44.
3. Remove hardware retaining chute gear cover to chute
pedestal and remove cover.
4. Remove spring clip from chute rotation rod and
remove rod from chute gears.
WARNING: AVOID INJURY. Before placing unit
in service position, close fuel valve and drain
fuel from tank and fuel system. See Draining
Fuel System on page 8. Make sure unit is
secure and will not tip.
Figure 43
1. Tapping Screw
2. Hex Shaft
3. Bearing Flange
1
2
3
Figure 44
1. Tapping Screw
2. Chute Gear Cover
3. Spring Clip
4. Chute Rotation Rod
1
2
4
3
To Next Page
Loading...
Need help?
General
