EN - 14
1
IMPORTANT: All references to left, right, front
or rear are given from the perspective of
operator in operator’s position, facing the
direction of forward travel.
EMERGENCY STOPPING
1. Release the operator presence control
(OPC) lever.
2. Models 911609, 911614 only: Pull back
and release REFLEX drive handle.
Model 911608 only: Release wheel drive
control lever.
3. Wait for moving parts to stop before
leaving operator’s position.
START THE ENGINE
1. Pull operator presence control (OPC)
lever against handlebar and hold position.
2. Pull recoil starter handle.
a. Grasp handle and pull rope out slowly
until it pulls harder.
b. Pull handle firmly and quickly with a
rapid, continuous full-arm stroke.
c. Repeat until engine starts. If engine
does not start, see Troubleshooting
on page 27.
MOW GRASS
1. Start the engine. See Start the Engine on
page 14.
2. Model 911607: Push handlebar to move
mower forward.
Models 911609, 911614: Engage
REFLEX drive handle to move mower
forward. Release REFLEX drive handle
to stop wheel drive.
Model 911608: Engage wheel drive
control lever to move mower forward.
Release lever to stop wheel drive.
3. To make turns, stop forward motion, push
handlebar down slightly and rotate mower
left or right.
REVERSE MOWER
IMPORTANT: Mower does not have a
powered reverse.
IMPORTANT: If mower wheels lock when
pulling in reverse push mower forward to
unlock wheels. If problem persists see Adjust
Wheel Drive Control Lever / REFLEX Drive
Handle on page 21.
Model 911607:
1. Pull back on handlebar to move mower in
reverse.
Models 911609, 911614:
1. Pull back on REFLEX handle to move
mower in reverse.
Model 911608:
1. Release drive level and pull back on
handlebar to move mower in reverse.
STOP ENGINE
Model 911607
1. Release OPC lever and move unit to a
flat, level surface.
Models 911609, 911614
1. Release REFLEX drive handle.
2. Release OPC lever and move unit to a
flat, level surface.
Model 911608
1. Release wheel drive control lever.
2. Release OPC lever and move unit to a
flat, level surface.
MOWING TIPS
• Cut grass when it is dry.
• Keep mower blades sharp.
• DO NOT set cutting height too low. For tall
grass, mow twice.
• DO NOT mow too fast.
• Vary cutting pattern with each mowing.
IMPORTANT: To prevent dirt and grass from
collecting on mower pan, avoid operating
over bare ground with only patches of grass.
MULCHING TIPS
• Cut no more than 2.5 cm (1") of grass per
cutting.
OPERATION
CAUTION: AVOID INJURY. Read
and understand the Safety section
before proceeding.
To Next Page
Loading...
