Ariens RAZOR 911607 - Storage Position; Vertical Storage Position

EN - 17
9. Pull lock collar away from washout port
and remove hose from port. See
Figure 18.
10. Remove coupler from hose end.
11. Start engine and engage blade for
approximately 2 – 3 minutes to remove
excess water from unit.
12. Stop engine and allow deck to dry before
storing.
Models 911609, 911614
1. Move unit to a flat, level surface.
2. Stop engine and wait for moving parts to
stop and for hot parts to cool.
3. Clean underside of deck with mild soap
and low-pressure water.
STORAGE POSITION
1. Move unit to a flat, level surface.
2. Stop engine and wait for moving parts to
stop and for hot parts to cool.
3. Rotate handlebar adjustment knobs 1/4
turn up or down.
4. Fold handlebar forward and align
adjustment knobs with front mounting
holes. Ensure pins are secure in
brackets. See Figure 19.
5. Models 911609, 911614 Only: Place unit
in vertical storage position. See Vertical
Storage Position on page 17.
NOTICE: Models 911609, 911614 are
equipped with engines that make it possible
to store unit in the upright position. To prevent
fluid leaks, DO NOT store Models 911607,
911608 in vertical storage position.
6. Return adjustment knobs to original
position.
VERTICAL STORAGE POSITION
Models 911609, 911614
IMPORTANT: Adjust HOC to setting 3 or 4
when storing unit in vertical storage position.
See Adjust Cutting Height on page 13.
See Figure 20.
1. Place unit in storage position. See
Storage Position on page 17.
2. Models 911609, 911614 Only: Tip unit
onto rear brackets.
1. Lock Collar
1
Figure 18
Figure 19