Arkray Assure PRISM MULTI - Inserting or Replacing the Batteries

13
SECTION
B
INSERTING OR REPLACING THE BATTERIES
The Assure Prism multi Blood Glucose Meter uses two 3.0 V lithium batteries. Before using
the meter, check the battery compartment and insert batteries if empty. When the
symbol appears on the display while the meter is in use, the batteries should be replaced as
soon as possible. The test results may not be saved if the batteries run out.
Step 1
Make sure the meter is turned off. Push the cover in the direction of the
arrow to open the battery compartment.
Step 2
Toremovetheusedbatteries,placeyourngerundereachbatteryand
pull upward. Insert two new batteries with the + side facing up and
makesurethebatteriesareinsertedrmly.
Step 3
Slide the cover back on the battery compartment. Push down until
you hear the tab click into place.
NOTE
• Removing the meter batteries will not affect your stored results. You may, however,
need to reset your meter settings.