42
Step 3: Obtain a blood drop
(see pages 38-39).
Apply
blood to the end of the test
strip. Capillary action will pull
the blood into the strip. The
meter will beep when it
detects that blood has been
applied. The meter will begin
to count down. Do not add
blood on top of the test strip,
as you may receive an inaccurate result.
Important: Ensure that enough blood is applied
to fill the check window and it turns red. When the
check window is filled with blood and a beep
sounds, remove the tip of the test strip from your
finger. If there is not enough blood, “E-7” or “Lo”
will be displayed.
To Next Page
Loading...
Need help?
General
