Arlo Pro 5S 2K - Set up an Arlo SecureLink connection between the Pro 5 S 2 K Camera and a Keypad Sensor Hub

22Wi-Fi Setup and Connections
Pro 5S 2K Spotlight Camera
User Manual
Connect your iOS (Apple) device to a Wi-Fi network
1. Unlock your device and tap Settings.
2. Tap Wi-Fi, near the top of the list of Settings options.
3. Turn on Wi-Fi by tapping the switch next to Wi-Fi at the top.
Note: Wi-Fi is activated when the switch is green.
4. Select the Wi-Fi network.
5. If prompted, enter the password for the network.
When you’re connected to the Wi-Fi network, a blue check mark appears to the le of the
network name.
Connect your Android device to a Wi-Fi network
1. Unlock your device and tap Settings.
2. Tap Network & internet > Wi-Fi.
3. Turn on Wi-Fi by tapping Use Wi-Fi at the top.
4. Select the Wi-Fi network.
5. If prompted, enter the password for the network.
When you’re connected to the Wi-Fi network, the word Connected appears under the
network name.
Set up an Arlo SecureLink connection between
the Pro 5S 2K Camera and a Keypad Sensor Hub
The Keypad Sensor Hub is part of the Arlo SmartHome Security System (sold separately).
Aer your Pro 5S 2K Camera is set up and active, you can pair it to a Keypad Sensor Hub using
Arlo SecureLink connectivity. Your Pro 5S 2K Camera and the Keypad Sensor Hub need to be
under the same Arlo Secure Account and in the same location.
The Arlo Pro 5S will also operate even if the Wi-Fi is down or during power outage if it is paired
to a Arlo Keypad Sensor Hub equipped with a Cellular and Battery Backup.
Note: Your Pro 5S 2K Camera cannot connect to both Arlo SmartHub or Base Station and a
Keypad Hub at the same time. To change your Pro 5S 2K Camera connection from a SmartHub
or Base Station to a Keypad Sensor Hub, you need to rst connect the Pro 5S 2K Camera it
directly to your router’s Wi-Fi, and then pair the camera to the Keypad Sensor Hub.