Armstrong Emech G1 - Changing Values (Set Point); Error Codes

6.5 Changing Values (Set Point)
When in Local mode pressing set and either up (+) or
down (-) the set point of each controller type can be increased or
decreased respectively.
Pressing set only will show the local set point or the remote set
point depending on which control mode the unit is in.
The error light shows errors. Flashing and solid lights denote
non-critical and critical errors respectively.
See Troubleshooting chart below in section 7.
The error type is displayed with a code form E0 to E9.
Current codes available are:
E1 = motor driver fault
E2 = temperature sensor fault (broken or not present)
6.6 Error Codes
Armstrong International
221
Armstrong Blvd., Three Rivers, Michigan, 49093 - USA
Phone (269) 279-3602 Toll Free (888) HOT-HOSE (468-4673)
35
Designs, materials, weights and performance ratings are
approximate and subject to change without notice. Visit
armstrong international.com/emech for up-to-date information.