Armstrong Emech G1 - Standard Operation Temperature Control

6.7 Standard Operation Temperature Control
Standard operation can be running in Emech system in “Local Mode” where set point is set on keypad “self temperature
control”.
• Emech Actuator system is in:
– “Local Mode”
– “Temperature Control Mode Deg F”
• LED “ON” are # 1 (=Deg F)
• LED “OFF” are “Local”
• Temperature Control is via Emech
Sensor and Temperature “Set point”
on the Emech actuator
– Temperature set-point via Keypad
Keypad Operating Instructions
armstronginternational.com
Armstrong International
221
Armstrong Blvd., Three Rivers, Michigan, 49093 - USA
Phone (269) 279-3602 Toll Free (888) HOT-HOSE (468-4673)
36
Designs, materials, weights and performance ratings are
approximate and subject to change without notice. Visit
armstrong international.com/emech for up-to-date information.