The Fixture Menu of the SkyPanel
29
To set the Color Temperature and Green / Magenta
Saturation in CCT Mode (only SkyPanel-C)
Set the color temperature continuously with the central rotary
knob (5). Set the green / magenta saturation continuously with
the right rotary knob (6). The current setting is displayed above
the rotary knobs.
To set the Color in HSI Mode (only SkyPanel-C)
Set the hue continuously with the central rotary knob (5). Set
the saturation continuously with the right rotary knob (6). The
current setting is displayed above the rotary knobs.
To set the Color Temperature and the Color in GEL Mode
(only SkyPanel-C)
Use the central rotary knob (5) to set the color temperature
3.200 K or 5.600 K. The right rotary knob (6) offers two options:
„Best color“ displays the gel with optimized color quality,
„Brightest“ displays the gel with optimized brightness.
Press I/S (4) to open the gel library. Choose the gel manufac-
turer (Rosco or LEE) with the central rotary knob (5). Use the
right rotary knob (6) to activate a gel category as shown in the
table below.
Turn I/S (4) to call up a gel from the gel set. Press BACK (11)
to close the gel set and set the intensity with I/S (4). Press I/S
(4) again, to re-open the gel set.
To set the Brightness in all Operating Modes
Set the brightness in both operating modes continuously with
the encoder I/S (4). The setting is dynamic: Turning the enco-
der fast changes the intensity in coarse steps, turning it slow
changes the intensity in fine steps.
To set the dimming curve
The SkyPanel supports four dimming curves. The dimming
curves are global: They affect both the intensity control via the
fixture menu or DMX and Art-Net.
• Linear: The intensity changes proportional to the encoder I/S
(4) or the channel value.
• Exponential: The resolution is high at lower intensity levels
and low at higher intensity levels. Use this dimming curve
when you need a high resolution at low intensity levels.
• Logarithmic: The resolution is low at lower intensity levels
and high at higher intensity levels. Use this dimming curve
when you need a high resolution at high intensity levels.
• „S“ curve: The resolution is both high at lower and higher in-
tensity levels and low at intensity levels in between. Use this
dimming curve, when you need a high resolution at low and
high intensity levels.
To set the dimming curve:
• Press the MENU button (10) to open the fixture menu.
Rosco LEE
Color Correction Color Correction
CalColor Color Filter
Storaro Selection 600 Series
Cinelux Cosmetic
To Next Page
Loading...
Need help?
General
