ARRI SkyPanel User Manual

The Fixture Menu of the SkyPanel
30
• Turn I/S, until „Light Control“ is selected. Press I/S to open the
menu.
• Turn I/S, until „Dimming Curve“ is selected. Press I/S to open
the menu.
• Select the dimming curve by turning I/S. Press I/S to confirm
the setting.
• The menu „Light Control“ closes automatically. Press the
MENU button to force closing the menu.
To set a special control mode
The SkyPanel supports two special control modes. The special
control modes are global: They affect both the intensity control
via the fixture menu or DMX and Art-Net.
• Low End Mode: The Low End Mode optimizes the dimmer
quality at low intensity levels and enables SkyPanel to gener-
ate accurate CCTs with high color rendition and smooth dim-
ming at very low light levels. The Low End Mode can cause
flickering when used with cameras shooting at high frame
ratzes.
• Tungsten Mode: The tungsten Mode can mimic the dimming
curve and strike on-and-off effect of a traditional tungsten
lamp. The CCT wamrs as the light is dimmed and when the
intensity drops to zero quickly there is a short afterglow of
warm light. This mode is perfect for mixing the SkyPanel with
tungsten sources or for producing a familiar effect.
To set a special dimmer mode:
• Press the MENU button (10) to open the fixture menu.
• Turn I/S, until „Light Control“ is selected. Press I/S to open the
menu.
• Turn I/S, until „Special Modes“ is selected. Press I/S to open
the menu.
• Select the special mode by turning I/S. Press I/S to confirm
the setting.
• The menu „Light Control“ closes automatically. Press the
MENU button to force closing the menu.
To set the DMX address
• Press the MENU button (10) to open the fixture menu.
• Turn I/S, until „DMX Settings“ is displayed. Press I/S to open
the menu.
• Turn I/S, until „DMX Address“ is displayed. Press I/S to open
the menu.
• Select the DMX address by turning I/S. Press I/S to confirm
the setting.
• The menu „DMX Address“ closes automatically. Press the
MENU button to force closing the menu.
To set the DMX Protocol
• Press the MENU button (10) to open the fixture menu.
• Turn I/S, until „DMX Settings“ is displayed. Press I/S to open
the menu.
• Turn I/S, until „DMX Protocol“ is displayed. Press I/S to open
the menu.

ARRI SkyPanel Specifications

General

Type	LED Soft Light
Color Temperature	2800K - 10000K
CRI	≥ 95
Dimming	0 - 100%
Control	DMX, Ethernet
Input Voltage	100-240V AC, 50/60Hz