Aruba 2930F Series User Manual

Japan VCCI Class A
Korea EMC Class A statement
Preview of installing an Aruba 2930F switch
IMPORTANT: This section previews the steps for installing the Aruba 2930F switches. To find detailed switch
installation steps, information on configuration tools, and other instructions and information, see the Aruba
2930F Switches Installation and Getting Started Guide.
1. Prepare the installation site.
2. Unpack the switch and verify that you have received the correct parts.
3. Connect power to the switch and observe the switch self-test, then remove power from the switch.
4. Mount the switch.
WARNING: Mounting restrictions apply. See the "Warning" under Installation precautions and
guidelines on page 2.
5. Connect the switch to a power source.
6. (Optional) Install transceivers.
7. Connect the network cables.
8. Configure the switch for network operation.
Documentation feedback
Send any errors, suggestions, or comments to Documentation Feedback (docsfeedback@hpe.com).
Page 6

Aruba 2930F Series Specifications

General

Model	Aruba 2930F Series
Operating Temperature	0°C to 45°C (32°F to 113°F)
Switching Capacity	Up to 176 Gbps
Ports	24 or 48 ports
Uplink Ports	4 SFP+ ports
SFP/SFP+ Slots	4
Layer	Layer 3
Power over Ethernet (PoE)	Available on some models (PoE+)
Stacking	Virtual Stacking Framework (VSF)
Management	Aruba Central, CLI, Web GUI
Features	sFlow, ACLs, QoS
Memory	512 MB RAM
Power Supply	Internal power supply