Page 20 Version 2.14 Maintenance and Service Manual
11. Adjusting settings
11.1 Adjusting the platform
The pitch angle of the platform can be adjusted with the sheet metal plates.
These are located on the bottom of the aluminium profiles.
Turn the reverse plates 180 degrees for raising the platform height.
! A T T E N T I O N !
Adjust the switch b20 (platform horizontal) if necessary!
11.2 Setting the safety bar slip clutch
The slip clutch is located on the safety bar
motor shaft.
Remove the plastic cover on the backside of
the lift.
Set the safety bars to a horizontal position.
Use a 10mm open ended wrench to adjust the
clutch.
! A T T E N T I O N !
Only adjust the clutch slightly.
The collar may not be moved!
Please note that each safety bar has its own individual slip clutch.
11.3 Adjust horizontal position of safety bars
The safety bars can be adjusted with the aid of the stop
screws which are moved by the lifting magnets.
! A T T E N T I O N !
Safety bar switches b5, b5.1, b6, b6.1 may need to be
adjusted. Please note that it’s important to make only
very slight adjustments to these switches!
Switch-cams are fixed with grub screws. To
adjust, first loosen grub screw, than turn the
cam.
To Next Page
Loading...
