EasyManua.ls Logo

Ascendor PLK8 - Introduction and Safety; Introduction; Health and Safety Regulations

Default Icon
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance and Service Manual Version 2.14 Page 5
1. Introduction
The equipment tools described in this Maintenance and Service Manual were those available at the time of
writing. Due to the continual development and improvement of our product we reserve the right to alter the
contents and technical data without consultation or prior warning.
A precondition for the uninterrupted operation of this stair lift, free of any technical problems is the strict
compliance with the content of this manual.
The manufacturer strongly recommends that the lift receives a routine service according to the service
schedule (see chapter 4) at least once a year.
This part of the user manual is dedicated to trained service technicians who are used to the service and
maintenance work of this product.
2. Health and safety regulations
2.1 General information
All service or maintenance work on the platform lift may only be executed by trained personal.
! N O T E !
In the interest of your own well being and the safety of third parties, please observe international health and
safety regulations and the applicable national laws at all time.
! A T T E N T I O N !
This lift is manufactured in compliance with the relevant international and national health and safety
directives. However that alone cannot guarantee safety and security. Incorrect operation or misuse of this
product can eventually cause heavy injuries of the user or third parties and result in damage to the lift and its
surroundings.
2.2 Safety precautions before starting service work
Ensure that the lift is disconnected from the main supply and
take precautions to prevent an accidental restart. In addition,
the batteries must also be disconnected before carrying out any
form of maintenance or service work.
Please take these following steps:
Unplug the battery charger from the main supply. If the
charger is positioned in the wall mounted box, open the
cover and unplug the charger.
Disconnect the batteries by unplugging the shown
connector.
! ATTENTION !
Disconnect the batteries before starting any form of service work!

Table of Contents

Related product manuals